You don't need to spend tons of money on expensive Kreg right angle clamps! This pocket hole hack is a great way to make sure that you get perfectly flush pocket hole joints every. Single. Time!

This Kreg Pocket Hole Jig Hack is super easy. Line up the joint, making sure the two boards are flush. Then, use an air nailer to shoot one or two pin nails into the end of the joint, holding the two boards in place. At this point, the joint is NOT very strong, but that's what pocket holes are for! Now, just use your driver to install a few pocket hole screws - no clamps needed! The pocket hole joint will stay perfectly aligned. No slipping or sliding.

For a final, professional touch, use a small amount of wood filler to hit the pin or brad nail holes on the face of the board.

What super awesome hacks do you use in the shop? Hit me up in the comments below!

Bored? Check out this cool mystery thing! amzn.to/37kAqiT (paid link)

-- Social Media --
Be sure to check out my Instagram: instagram.com/imakejake/
and of course, my website, www.imakejake.com/ where you can find more awesome plans and projects!

Make with Jake is a channel dedicated to providing you with practical shop tips, guides, and plans so that you can spend more time BUILDING and less time messing around doing dumb stuff....check out this killer DIY Kreg Jig Base and SAVE MONEY!    • Save MONEY!  DIY Pocket Hole Jig Base!  

I wrote a book!!
Grab your very own copy of the Woodworker's Notebook on Amazon: amzn.to/2Uy4h0F

Don't forget to LIKE and SUBSCRIBE!

imakejake.com and Jake Drews is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com.
#pocketholejigsystem #shorts #makewithjake